It could prove to be an interesting four days coming up.
I was giving the 52-Set a routine workup two nights ago, running the receiver for about 20 minutes with the Sender Heaters active. Then switched on the Netting to run the 300 Volt Dyno for 3 or four minutes. I then switch Netting off and switch the set from Reeceive to Send. This turns the 300 Volt Dyno back on with the 1200 Volt Dyno. I normally let this pairing run a couple of minutes and power fully off. Done this several times a week for nearly three months.
This time...not 5 seconds from switching to Send, I could smell burnt varnish/wax coming from the Sender Blower Door so switched off immediately. So this weekend the Sender comes out of the Carriers No. 4 again for a close inspection.
David
|