View Single Post
  #3  
Old 03-07-22, 03:06
daninnm's Avatar
daninnm daninnm is offline
Dan Dolan
 
Join Date: Feb 2004
Location: Albuquerque, NM, USA
Posts: 132
Default

I'm calling Reg - but don't think he is a radio expert. Hoping to see if here is a am operator knowledgeable.... but I do have a call in to him....

This is what I have traced so far:::::

Studied the wiring diagram for the M-4 US TANK CIRCUIT in the No 19 set wireless book…. see if I am correct. Trying to use that as a basis for the Staghound wiring.
1. The Commander’s box controls the radio though the 12-pin cable that connects from his headphone ox to the radio itself.
2. The “Commander Call” button boxes (owned by the driver and bow gunner) and the two other guys in the turret is connected to
SPEECH – Terminal 2 in the Comm box
12 v+ Terminal 45 in the Comm box
SIGNAL Terminal 4 in the Comm box
MIC + Terminal 3 in the Comm box
MIC - Terminal 4 in the Comm box
Big Question: are the wires in the cable out of the No.1 and No.2 Mk II call boxes all the same color coding? I see six wires and a ground/shield around the entire 6-wire bundle.

On the M-4 diagram there is also a table that shows the wiring color from the headgear cords – is that color scheme follows through from the cords that come out of the boxes……?????
I have a large WHITE and LARGE BLACK
Large Black SIGNAL
Larage White Terminal between SIGNAL and SPEECH
Smaller: Blue GND’ed at box
Green GND Between MIC and EARTH
Red MIC
Yellow SPEECH
Pink between SIGNAL & MIC wires on No. 1 box terminal strip

Am I missing anything?????
Reply With Quote