Flick Indicator Flags
With some available free time today, I managed to get the masking of the Flick Indicator Flags for the flat black coat of paint sorted out and the painting done.
The flags are 13/16 inches long, split in the middle with the flat black paint being applied to the bottom halves. I decided to go with cut down strips of Post It Note paper again to mask off the upper halves of the flags. Once in place, I augmented them with small pieces of painters tape to ensure the guide edge for the paint stayed put when hit with the spray paint spray.
I measured back 13/32 inch from the glue end of each Post It Note and penciled a line across the top of a 3-inch square note. Then cut each note in half to form a pair of masks for each set of flags. Using the pencil line to line up at the top of each flag, I pressed them home and them did the painting tape thing to keep them all down.
Again, KRYLON is my go to paint and I was using their Satin Black #48823. About 10 to 15 minutes after the spay work was done, I removed the Post It Note masking, leaving just the original paper set down before starting work on the flat white paint earlier. Again, it will take about a week for the flat black to cure hard and then I will be able to do the hand application of the luminous Natural Green paint over top of the flat white upper sections of the flags.
David
|