PLATES, Stop, No. 1 ZA 14522
I decided todays project would be simple, but important.
The five small screws and lock washers used to secure, and adjust, the upper ends of the PLATES, Stop No. 1 needed to be cleaned up and reinstalled.
Although their primary function is to allow the PLATES, Stop to be adjusted to correctly match the upper and lower limits of the tuning indicator dials with the actual frequency limits of the set, they are also critical for securing the upper parts of the Flick Drive Assemblies for each of the three tuning dials on the Sender. Without them in place, the Drive assemblies can flop around behind the panel a bit. Not a good thing.
You can see in the attached photo, compared to the one previously posted above, the five PLATES, Stop No. 1 on the Sender front panel are now back in their proper fixed orientation, not just hanging around on their lower rivets.
David
|