can't go anywhere unless I finish the roof
Next step was to reread all the posts and I picked up on the order of putting the interior back in, start with the roof! The inside ceiling panels were cut and placed and i tried for the original holes in the frame to start but quickly went to self drilling screws to secure the roof panels tight to the roof, had to router a groove for the wires around the powered roof exhaust and to where the switch would end up as there is no longer any void to pass them through, air grinder was used from the top to hog out the chimney and vent holes and trial fit all the vent and chimney hardware. They had beened stripped, primed and painted in the same time period. oh yes, another generous application of Polyurethane. Hint: Zylene cleans it off.
|