Ford CMP- Drawing: Bumper dimensions
Good Day,
Recently I sold some Ford CMP bumper brackets and the purchaser asked if I could provide dimensions of an original bumper with a view to fabricating one.
Attached is a drawing of the earlier version bumper with the hole for the reflector jewel which I supplied taken from an original on my truck.
This drawing may be of use to others.
Finding the steel may be the hardest part. That seems to be a unique profile when I checked my very old Bethlehem Steel handbook. No doubt a wider flange could be cut/ground down to replicate the original width flange, or a fabrication job with a bit of welding and grinding. The channel was rolled, and not folded, to that shape hence the square edge at the top and bottom of the bumper.
I have checked, and double checked, dimensions but if you use this drawing I recommend you check them yourself or use a wooden template first. To paraphrase a well used woodworking term: "Measure twice and drill once"
Hope this is of some interest.
Cheers,
__________________
F15-A 1942 Battery Staff
Jacques Reed
Last edited by Jacques Reed; 27-02-21 at 06:48.
Reason: comments on original manufacture
|