View Single Post
  #78  
Old 28-06-12, 21:51
Hanno Spoelstra's Avatar
Hanno Spoelstra Hanno Spoelstra is offline
MLU Administrator
 
Join Date: Feb 2003
Location: The Netherlands
Posts: 14,400
Default

Quote:
Originally Posted by Wayne Henderson View Post
Hi Hanno, I did see the original thread but that was for a 15A and different to what I'm after for the 2WD.
My apologies Wayne, I didn't realise you were after 4x2 brake lines. The rear chassis to diff hose is the same as on the 4x4 Ford and Chev, for the front brake hose you would have to find a replacement part for the original one.

Looking at my posting F15A brake lines, I note the part number *C01Q-2079, the flexible hose running from chassis to front wheel brake cylinders as per "old location", is the same for the flexible hose running from the chassis to front axle as per "new location". This is Raybestos BH25629.

HTH,
Hanno

Quote:
Originally Posted by Hanno Spoelstra View Post
First I had a close look at the maintenance manual and spare parts list:

“Old location” (fig. 1):

Rear: metal brake line (p/n 91A-2269) running from master brake cylinder (p/n 91T-2140) to rear of chassis, flexible hose (p/n *C01Q-2078) from chassis to rear axle, metal brake lines (p/n 91A-2269) run from connector (p/n 01T-2074-A) to rear wheel brake cylinders (p/n (C) 91T-2261). Note the flexible hose is fitted to chassis bracket (p/n 01T-2073) with the use of a clip (p/n 78-2814-A).

Front: metal brake lines (p/n 91A-2269) running from master brake cylinder (p/n 91T-2140) along left and right frame channels above front axle, flexible hose (p/n *C01Q-2079) from chassis to front wheel brake cylinders (p/n C91T-2261).

I suspect this setup was taken over from the 2-wheel drive F15 to the 4-wheel drive F15A, and later relocated to the setup described below as it better suits a front drive axle.

http://www.surfacezero.com/g503/data...stem_fig_1.jpg
Reply With Quote