Bruce need your help again...
On previous emails to Peter S..... on this side of the pond....
you wrote:
This is for the #2 power supply.......for a Canadian Mark III .........PS are they all the same?????
pin1 -12v heaters, -12v dynamotor & gnd
pin2 i/c speech
pin3 +12v heaters & relay
pin4 +12v vibrator & dynamotor
pin5 signal
pin6 -12v vibrator
If working only from the vibrator it is advisable not to power the i/c, A set & B set all at once as it loads the psu. Besides, there's nothing like the scream of a well lubed dynamotor.
Had to delete part of my message previous as it did not make any sense.
What I am trying to do with the above information is verify/confirm that the 12 volts cables from the CPP-2 PS are of the correct polarity because the ends that connect to the CPP-2 PS are not clearly indicated. I will use a simple continuity tester to check out pin numbers and clearly mark my cables for future reference
Again many thanks.
Bob C.
__________________
Bob Carriere....B.T.B
C15a Cab 11
Hammond, Ontario
Canada
Last edited by Bob Carriere; 09-01-14 at 01:36.
Reason: All mixed up
|