View Single Post
  #22  
Old 06-07-18, 08:22
Jacques Reed Jacques Reed is offline
VMVC
 
Join Date: Jul 2012
Location: Victoria Australia
Posts: 858
Default Ford CMP cowl wiring- Australian cab, dip switch

Hi Keith,

Thanks for that information and photos.

It answers two questions:
It doesn't look like double connectors are used even if they would do the job, and it appears the leads from the dip switch go into the rear of the middle and lower terminals of the upper junction block (Hi and low beam respectively)
I will therefore connect the right headlight to the short tails at the junction block with just single bullet connectors and bring the leads from the dip switch to the rear of the junction block.

I will wire it up that way unless something else comes along to prove otherwise. I notice there is a small clip on the foot plate near the clutch pedal bump pad which may help to prevent the dip switch harness from getting chafed.

Thanks again,
__________________
F15-A 1942 Battery Staff

Jacques Reed
Reply With Quote