View Single Post
  #20  
Old 07-03-21, 11:34
super dave super dave is offline
Dave Good
 
Join Date: Dec 2003
Location: Onoway, Alberta, Canada
Posts: 686
Default

In the front timing cover there is a access hole and it you use a 6mm Allen key as its a cap head bolt. as for the brushes there is a small hole in the back of the brush holder so you would install the brushes and the springs then push them down and then you would insert a small piece of wire across both of them to a small hole on the other side to hold the brushes down until you install the regulator than remove the wire once you feel the regulator sitting on top of the wire, See pics. Hope this helps.
Attached Thumbnails
20210307_025224  33.jpg   20210307_031902 34.jpg   20210307_031948 35.jpg  
Reply With Quote