[Alex van de Wetering]

Here is a picture of my "custom" seatpost, which is essentially a seatpost with the correct "BSA" measurements, which I shortened. I than welded a new steel tube with a slightly smaller diameter into the seatpost.

Also pictured is the bolt for the steering wheel. I measured up an original BSA steering wheel and looked for a replacement. I found an old chromed example with nearly the same shape and measurements, so I decided to use this as a base. I drilled a hole trough the bolt and inserted a piece of rod which I bent into the "wingnut" shape. A few welds to secure it and to creat a slightly domed end to the bolt. I than cut the ends to the correct lenght and welded a little bit of material to the ends, creating the rounded ends.

Next up.....the BSA chainwheel, cranks and peddles.

Alex