[jason meade]

Tony, Dont worry about the small stuff Buddy...Thats the one i thought you were having problems with, then this afternoon Alex said something about a speedysleve....and i wondered all afternoon about how you were going to fix that with a speedysleve...lol
No worrys, Just follow what i said earlyer and you will not have any problems..I have rebuilt several splicer units with the front bearing cap off you can get to it from the other side, if not use a small flat screw driver and start digging er out, but remember when the seal is out make sure there is nothing else in the hole.
I have found metal spacers and gasket spacers between the seal and the cast face.
Good luck
Jason