Carefull measurements.....
HI Gary
If you take ID and OD measurments to an industrial bearing shop all the parts....bearings and races are still available.... you may need to invest in some speedy sleeves to cover wear grooves in the yoke's shaft surface......
....about $700 worth for a full set for a 2 speed T-case.
Carefull with the metal shims....cut new paper shims with a very light coating of silicone....... you may need another spare T-case for extra shims...... gears have to be preloaded just right.... final results you should be able to rotate the yokes by hand... too loose it will rattle..... any tighter will be too much.... MB-C2 is a good guide for the set up.....
I pre-greased all bearings with a light coating of moly lub during assembly....
I also used synthetic lub...... nice but as a tendency to leak.... like a CMP was designed to do .......
__________________
Bob Carriere....B.T.B
C15a Cab 11
Hammond, Ontario
Canada
|