I made up this plating fixture last evening to use with the brass tubular rivets I need to zinc plate. It is made from a 16-inch piece of 12 gauge, solid copper wire, as this size fits into the hollow core of the rivets just nicely.
This morning, I cleaned the two rivets with a commercial solvent, dropped them for a couple of minutes in a 3:1 dilution of Hydrochloric Acid for a final clean, and then rinsed them in a small container of plain water before setting them up in the jar of Zinc Electroplating Solution.
They are bubbling merrily away and I shall leave them to it for 45 minutes. It will be time to check them in about 15 minutes.
I shall keep you posted.
David
|