View Single Post
  #1095  
Old 23-05-20, 12:24
colin jones's Avatar
colin jones colin jones is offline
Registered User
 
Join Date: Jun 2007
Location: Adelaide
Posts: 1,810
Default

OK so the problem was the photos were too big and for some reason it up ended them Anyway I will have to remember that. The Chev engine is in and it is a very, very close fit but that's OK as long as it is in. I custom made the exhaust and that too is fitted. I have to do some linkage and final drive completion which will take a while.

Chris, to answer your question about my CNC Plasma cutter. I am running a Hypertherm 85 and it does the job for me but is a far cry compared to a water jet.
Speed, air pressure and amps per cut is something that needs to be played with to get good results and of course clean tips. I also have a air dryer above my compressor and run it for at least 10-15 mins before I cut anything as water in the air is a definite no no.
Colin.
Attached Thumbnails
20200523_171929.jpg   20200523_173044.jpg   20200523_173052.jpg   20200523_173103.jpg   20200523_173125.jpg  

Reply With Quote