TERMINALS, Aerial, No. C1 ZA/CAN 4716
The TERMINALS, Aerial, No. C1 was remounted to its new phenolic board this morning and the terminal feed wire reconnected to it.
As with the Remote receiver some time back, I took the time to mark the terminal feed hole with a toothpick and aligned it corrected with the location of the Eye Bolt the Receiver Feeder Cable passes through, just before connecting with this TERMINALS. The Feeder Cable is an exact length and in accordance with the factory photos in the 52-Set Manuals, comes off this Eye Bolt and runs straight into the Sender Terminals.
I found my ¼-Drive Ratchet with a medium slotted screw driver head wound just fit carefully behind the front panel to run the TERMINALS screw home with one hand, while keeping the TERMINALS correctly aligned with the other hand.
Not only is this part now solidly remounted to the Sender for the first time in however long, but also one of three electrical feeds I had to undo to remove the front panel, is now restored.
David
|