I was in the mood, and had the time, to remove one of the Tag Boards from the rear of the parts receiver chassis this morning. If any of you are familiar with Allan Isaac’s restoration work in England on the 52-Set receiver, this is referred to as the ‘ER Tag Board, and was located in the empty section of chassis in the lower right section of this photograph, below the V2B socket, where the two small mounting posts are now visible. If you refer back to Photo 1 in Post #580, you can see this board as originally mounted on the chassis of a receiver.
The work went rather well with just a pair of needle nose pliers and the soldering iron to remove the relevant leads.
A screwdriver was then needed to remove one grounding strap and the two mounting screws for the board.
David
|