I managed to get another day or three on the ford chassis
I have removed the remaining welds of the attachments
The welds were high strength, therefore hard and time consuming to grind, with barely any sparks coming from the disc
I have straightened any bends in the top and bottom of rail sides
I have fill welded all the extra cut holes in the rails, and filled the bigger ones in this cross member
The welds have all been ground back flush, and then disc sanded
I found a swelled section between the outer and inner chassis rails, behind where I had removed the cross member, so I cut a piece out of both inside rails, finding plenty of rust from the inside of the inner thin rails, and will replace these pieces after the sandblasting
I have done the 'total bolt removal' and now a 'partial rivet removal' with the damaged front engine mount crossmember, and the radiator mounts removed
I have also removed these parts out of the 'crane' chassis ready to go in
All these pieces and the chassis are scraped and wire wheel brushed clean, along with the mudguards, ready to sand blast
I hope I am at the bottom of the deconstruction, because this dismantling does not feel like progress, and the outside workshop looks like a Blitz grave yard
time for