Lynx Axle
Hi Harry,
To make a new axle, get one from a C8 CMP, and weld up the splines and then get machinist to recut the spline from what was 10 to the Lynx's 12 spline.
Cost is about $150 to cut the splines. To match the look on the end of the axle
,just grind the casting knob off. The inner crown wheel hemisphere is from a 1940 One ton Ford truck, only difference there was the Lynx used a 35 tooth crown wheel, Cheers Andrew.
__________________
Valentine MkV
Covenanter MkIV
Lynx MKI and MKII
Loyd Carrier / English / Candian / LP.
M3 Stuart
|