View Single Post
  #870  
Old 28-05-22, 18:55
David Dunlop David Dunlop is offline
Registered User
 
Join Date: Feb 2006
Location: Winnipeg, MB
Posts: 3,384
Default

This morning was spent marking out and drilling the three holes in the copper bar, for my Ground Terminal Project. The hardware is all ¼-inch brass, but I went to 17/64-inch for the hole size, just to make assembly a little easier.

Once the holes were in the copper bar, I used the bar as a template for getting the two terminal post holes properly centered on the cover of the electrical box.


David
Attached Thumbnails
Ground Terminal Project 5.JPG   Ground Terminal Project 6.JPG   Ground Terminal Project 7.JPG  
Reply With Quote