SCREW-EYES, ANC, Steel, 4-40, 1/4 inch shank ZA/CAN 4333
I am going to use the shank of my 3/8-inch drill bit to reform the damaged Screw-Eye off the Supply Unit. The attached photo shows the start point of the basic concept. I am in no rush and the bulk of reforming the correct circumference of the screw-eye should be relatively straightforward.
Where it is going to get challenging is at the point of closure between the end of the ring, as it gets closer to the shank of the screw. The shank must maintain an orientation of being perpendicular to the circumference of the ring of the Screw-Eye. Or to put it another way, the shank of the screw must point to the centre of the eye when I am finished.
David
|