Front Axle Yoke Seal
Greetings,
I have been working on my 67' M38A1 all summer replacing seals and gaskets that in the last two years have started to leak.
I just finished the front transfer case yoke seal....it was easy as the yoke just slid off the shaft not requiring a puller and since it has no crush sleeve was easy to tighten up.
I am now about to start the front axle yoke seal and it looks different from the two on the transfer case yokes/flange. Will it be as easy as the front (transfer case) seal? Does the front yoke have a crush sleeve to worry about? Is the seal of a different design from the front transfer case seal? In short, will replacing the front axle yoke seal be as easy as the front transfer case yoke seal?
Any info or advice would help,
Regards,
lesk
|