SUPPLY Unit ZA/CAN 4772
I was able to finish cleaning the fan blade this morning and it now slides on and off the shaft of the Blower Motor quite nicely.
The two blades that had assumed the lower position while the 52-Set sat idle for years had quite a bit of rust accumulation that showed up as a darker area of small pitting once the blades were cleaned and polished. Whatever company made these fan blades did a very nice job of the nickel plating. It is very heavy duty and has held up well over the years, all things considered.
David
Last edited by David Dunlop; 19-02-22 at 04:35.
|