AERIALS, Horizontal, 4-Section ZA/C 00087
Thank you for your comments, James.
As predicted, today has been a major rain and thunderstorm day, so no polishing, to which my fingers are eternally grateful!
Before the rains arrived, however, I did accomplish some good errands. I picked up another 75 ml tube of polish and found it is now pushing $18.00 Cdn a tube now, but still well worth it.
I also dropped into the local RONA and bought an 11 foot length of rubber sheathed 16/3 power cord to replace the one on the new CPP-2. when I feel up to moving it again.
The other thing I did was take a look at some modern electrical components I thought would be suitable replacements for fittings needed to eventually replicate the AERIALS, Horizontal, 4-Section used with the Wireless Set No. 52.
The 14 gauge 7/22 Hard Drawn stranded copper aerial wire is still readily available in the United States, but seems to have disappeared out of the usual Amateur Radio markets here in Canada. I am not about to order any at the moment though. I realized I now have 13 parcels sitting at my local US Border Mail Depot I cannot retrieve because the border is still closed. No need to be adding to that right now.
Geoff Turcott sent me a couple of detail photos of his 52-Set aerial and it looked like some modern items would be good fits.
The two attached photos from Geoff show the Section quick connect/disconnect fittings, and the splice fitting between the end of the aerial and the Feeder Cable to the Set.
The third photo shows the modern substitutes I found, They are all MARR 14 gauge crimp connectors. The photo shows the packaging, the fitting with blue insulation attached and with the insulation peeled off. The Male/Female Bullets will work nicely for the Section Connections and the Butt Splice Connector for the Aerial to Feeder Splice. I will crimp them all as well as solder the fittings, when I get to that part of the project.
One other fitting to look into locally and that part of the project should be good to go.
David
|