View Single Post
  #1  
Old 12-08-19, 23:43
James D Teel II James D Teel II is offline
Registered User
 
Join Date: Jun 2019
Location: Edmond, Oklahoma, USA
Posts: 133
Default WS 19 MkII jeep install questions

All,

I’m installing one of my MkII 19 sets in my jeep. I’ve not seen any install instructions for a Jeep, so I’m just interpolating from some of the install instructions I’ve seen. For the power cable, am I correct in thinking that I need either the Connector, Twin, No. 88, or the Connector, Twin, No. 194?

I’m also going to need an Aerial Feeder Assembly, but which one?

Lastly, this set has been inactive for years, but I’ve opened it up and it looks good on the inside. From what I’ve read, I need to apply low voltage, approx 3 volts for about four hours. If nothing grenades, then I need to gradually increase the power until I get to full power, that being 12 volts. Just how am I supposed to accomplish this?

V/R

James D Teel II
Edmond, Oklahoma
MVPA 30889
__________________
V/R

James D. Teel II
Edmond, Oklahoma
Retired Police Sergeant/Bomb Tech
1943 Willys MB/ITM jeep
1942 SS Cars No1Mk1 LtWt trailer
Reply With Quote