Quote:
Originally Posted by David Dunlop
...
The other thing I did was take a look at some modern electrical components I thought would be suitable replacements for fittings needed to eventually replicate the AERIALS, Horizontal, 4-Section used with the Wireless Set No. 52.
The 14 gauge 7/22 Hard Drawn stranded copper aerial wire is still readily available in the United States, but seems to have disappeared out of the usual Amateur Radio markets here in Canada. I am not about to order any at the moment though. I realized I now have 13 parcels sitting at my local US Border Mail Depot I cannot retrieve because the border is still closed. No need to be adding to that right now.
Geoff Turcott sent me a couple of detail photos of his 52-Set aerial and it looked like some modern items would be good fits.
The two attached photos from Geoff show the Section quick connect/disconnect fittings, and the splice fitting between the end of the aerial and the Feeder Cable to the Set.
The third photo shows the modern substitutes I found, They are all MARR 14 gauge crimp connectors. The photo shows the packaging, the fitting with blue insulation attached and with the insulation peeled off. The Male/Female Bullets will work nicely for the Section Connections and the Butt Splice Connector for the Aerial to Feeder Splice. I will crimp them all as well as solder the fittings, when I get to that part of the project.
One other fitting to look into locally and that part of the project should be good to go.
David
|
Do you need the wire clips for the chain-link insulators? I think I have some insulators with them fitted in the "bits box"...
I'll also see if I can get decent photographs (and measurements) of the multi-section WS19 aerial I've got (6 sections + two insulator strings) which I think was an early attempt at replacing the Truck & Ground station set of 6 wire aerials. (Except that the manufacturer Got It Wrong and the first section is 10 feet too long....)
Best regards,
Chris.