Thread: Info needed: C15A 2B1 cargo bed rebuild
View Single Post
  #18  
Old 18-08-22, 23:35
Grant Bowker Grant Bowker is offline
Registered User
 
Join Date: Jul 2006
Location: Ottawa, Canada
Posts: 2,285
Default

A steel panel was attached to the marked holes, extending down and to the rear with the rubber flap attached to the lower edge. Bob does/did have an original steel panel (damaged by abuse), but not the rubber flap. I will try to harass him into providing measurements (and hopefully photos). Attachment of the rubber to the steel panel was bolts/machine screws passing through a metal strip (approx 1"x1/8" from memory) then through the rubber and finally through the steel panel. After looking at the panel agian, I now believe the bolt head was forward with the bolt passing through plate, rubber, reinforcing strip and finally nut toward the rear.
It's likely going to be at least Sunday for measurements/photos.

Last edited by Grant Bowker; 22-08-22 at 01:30.
Reply With Quote