[Jonathan Moore]

All the holes have now been drilled so it was on to the machining of the recess in either side of the sprockets. To start with I counter bored the flange and then tapped a number of the holes so that I could bolt the sprocket in place rather than just relying on my tack welds.
Again I used the modified Land Rover hub but by using a spring loaded stop I turned the whole assembly into a sort of ratchet. If you remember I am rotating the assembly by hand using a long bar, so if the cutter were to snatch, especially at the start of each cut, it would try to rotate the sprocket at the speed of the cutter (500 rpm) in the opposite direction to the one that I am trying to turn it, taking my arm with it and ending in a big bang. As you can see from the pictures, the stop rests against each tooth of the sprocket in turn, stopping it rotating in the wrong direction and as the sprocket is rotated the stop moves accordingly.