William
refering to Ken Hughes' pics:-
the basic dimensions of the pintle frame parts are as follows:
The plate holding the hook below the rear cross member is 6 inch x 11 1/4 inch x 1/2 inch plate
The side plates off the chassis rails are 6 inch x 10 1/2 inch by 3/8 inch plate.
The angled brace connecting the above plates is 3 inch x 1/4 inch flat, about 56 inch overall.
The end of the pintle shaft is supported by a folded channel which has a 3 3/8 inch web and 1 3/4 inch flanges ex 1/8 inch plate.
I'll attach some sketches I've done, though bolt hole details are missing.
Rob
C8AX Ambulance (NZ)
|