[Bob Carriere]

...and to make matter worst.....


Did you know "FURD" also made the Chebby brake drums.....



NOW for a legitimate restoration questions.....

...how do you remove the large seal inside the drum without butchering it????

.....how do you remove the bearings????

if you look at the picture above,,, the outside of the brake drum had 3 threaded holes for the cap....... I imagined that I could put 5/16 bolt in there and push out the inside bearing... no such luck the holes are deadened......

NOTE... so far all bearing show extensive wear and will all have to be replaced.