COIL, Aerial Tuning No. 2 A ZA/CAN 4725
The last step in removing the Dial Lock assembly from the front of the Coil, Aerial Tuning No. 2 A is the removal of the SCREWS, Brass, Special ANF 10-32, 23/32=inch long No. C1 (ZA/CAN 4831). It is held in place with three ANC 2-56 x 3/8-inch, brass, CS slotted machine screws, with matching flat washers, Shakeproof washers and hex nuts on the back side of the panel.
Here is where the SCREWDRIVERS, Electricians, 3-inch, IF 117350, from the 52-Set Tool Box comes in real handy. It fits the countersunk screw heads perfectly.
The 3/16-inch socket from my ¼-Drive set fits the hex nuts and all three came free perfectly. All three hex nuts still had their Shakeproof washers under them but only one flat washer has been found. I will have to try and find some others to replace the missing ones now.
With the SCREWS, Brass, Special out of the way, the last two items to remove from the front panel were the Data Plate and the PLATES, Phenolic, Calibration ZA/CAN 4361 to have as open as possible a front panel for stripping and repainting.
David
|