COIL, Aerial Tuning No. 2 A ZA/CAN 4725
With the sanding and stripping down of the NATO Green paint on the exterior of the coil case and back cover completed, I have been focusing on getting this paint off all the 1/4-inch and 1/2-inch surfaces created by the recess cuts for the front panel and rear cover, and the six 1/2-inch square reinforcing strips in the four box corners and backing for the rear cover.
It has been very slow but steadt work. I have now assembled a nice assortment of tools that work well on this small stuff in tight spaces and have worked out a fairly reliable pattern. Once I can break through the heavy coat of NATO Green, I have found the pine has a pretty good hardness about it, such that a hard steel edge can actually chip chunks of the paint of very easily. The only tricky bits so far are the presence of saw ridges on some of the 1/2-inch strips that require a bit of sanding to smooth down first.
The last of these small pieces I have to clean now are the inside faces of the four pine strips that form the backing for the rear cover. I need to have the case resting on its back on the bench with several gooseneck lamps in close to properly light the interior of the case to see what I am doing, and reach down and in at a steep angle. I end up starting at a midpoint and moving to one end, vacuum the bits out and then swing the case around to clean up the opposite direction. Slow but steady.
I will try and sort some meaningful photos out this weekend.
David
|