Well that was not the end of the story
I have attached an update on my adventures in rebuilding the replacement engine for our F60S LAAT.
However, I now have a real problem. The reach from the timing cover to the end of the camshaft is about 0.91 inches. This is about twice the reach of the distributor. I seem to remember reading about this on this forum some time ago but cannot find it again.
Is there an adaptor?
If not, can anybody tell me if the dog on the distributor is held on with a roll pin, taper pin or something else? Close examination has not helped me. If I can get it off, I can make a longer one.
Does the distributor that has two bolt fixing have a longer reach?
I feel thoroughly faint at the prospect of swapping camshafts as I have got this far.
Kind regards,
Alastair
F60S LAAT
Ford Lynx I MkIII*
|