Quote:
Originally Posted by Phil Waterman
Hi Guys
In the last several posts some interesting things have come up. Maybe we need a discussion of how to install and fit the bushings and pins.
For example you need to have a pin in the bushing as it is pressed into the spring eye to reduce chance of distorting the bushing if the spring eye is not round.
Or pressing the bushing in instead of driving it in.
Or leaving the old bushing in place and putting a long snug fitting rod through the old bushing and the new bushing and using the new bushing to push the old bushing out as the new is installed.
Buying bushings that to long and cutting them off to fit after they are installed.
Just some thoughts.
Cheers Phil
|
My method is to place a stake or wide blade into the split end of the eye of the spring and spread it slightly prior to installing a new bush. It takes a bit of force but with a 12" cold chisel with a 1" blade you can hammer it into the split and spread the eye just enough to make the bush slide in with little effort. Being mindful its spring steel and it has a force stored when you do this!
The bushes must be pressed in and not hammered using a solid tube as close to the bush diameter as possible. (some sockets are good). With the eye spread the bush sometimes goes all the way in, but a press is handy for the final placing.
That is a good tip to add the centre pin, I haven't done that in the past, but it would reduce the chance of crushing your nice new bush. (been there, & done that)
Having reamed the eye hole with a brake wheel cylinder hone and suitable lubrication first.
Its a messy job and you have to go slowly so as to not damage the hone.
Cheers,
Ian