Panel Reply
Hi Rob & Terry....thanks for both reply's....I agree with Terry....I am sure that all the questions & responses in this post have been done before.....but probably not all in one place/post....case in point...I have saved all the questions & responses from Rob and et Al in a word document.....when it comes time to actually work on the jeep when parts start arriving....I have the info-details from people that have actually been there as well as following the 3 manuals I bought from Brian Asbury.
OK Rob....another question regarding the shorting of the panel just to confirm...as per you email...."you either have to run a ground to the panel, or else re-install the panel back in place. The best solution is to make up a short wire permanently installed form the dash to the panel."
So, Question....if the panel is off...and you have completed the replacement of the EG: temp gauge & sender you can replace the panel to the dash before you turn the ignition on and you should be golden....correct? It sounds like the bottom line is that you cannot turn on the ignition before you put the panel back on the dash to ground the panel...correct?
les
|