Tape up holes and POR 15
Hi Jordan
I removed the door latch assembles, taped up all the holes, but one, poured in quart of POR 15 sealed the last hole then rotated the door slowly in all directions. Then drain the excess and repeat with the next door.
Just be sure you are done welding on the door.
Note- Please read Jordan's response, down two, I must have been lucky and used better tape but the lesson is well put use really good tape and clean the metal on the outside first.
Cheers Phil
PS Tell you how it worked at preventing rust in about 50 years.
Last edited by Phil Waterman; 09-09-16 at 23:07.
Reason: Additional Info
|