[Bob Carriere]

Finish the door with paint and new inner skins..... paint the seat frame and install and waiting for the 30Ohms senders for the fuel tank......

...... than road trip!!!!!!

It sure made my task a lot easier to have a "perfect" wiring loom to work with. I followed your practice and did soldered joint on all connections then skrink/heat wrapped. Connectors in the mid section were coated with di-lectric grease during assembly.......all carefully clipped to the frame....especially near the master cylinder......

Will be installing a manual turn signal system which uses a large switch similar to the fuel gauge switch.

I will be running "roadster" style like you without a top and plan to install the original rusted out cargo box as fenders are required....sort of a "work in progress"

Top needs a lot of small bumps to be removed and replace about 6 inch strip near the middle joint.

The cargo box will be reverse enginered later on...... I have 3 rusted hulk to work from.

One question on the harness you supplied Rob for his HUP....did you use the same wiring diagram or did you make a "one off" for his HUP????

A thousand thanks

Bob C