View Single Post
  #21  
Old 10-03-16, 01:45
Bob Carriere Bob Carriere is offline
Moderator
 
Join Date: Mar 2003
Location: Hammond, Ontario
Posts: 5,259
Default Dare ask.......

Hi Alex

I have 3 rear 2B1 bodies or maybe should be called cadavers......

I have my original cab 11 box and two from Cab 12.

Sadly all of them are badly rusted BUT between the 3 boxes I have one badly twisted tail gate and two sets of good side drop panels.

Only one cab 12 floor still has the original inside the box rectangular fenders.

Plans are to reverse engineer and built one new box. I have enough to use as patterns for a new fabrication. Mainly 14 and 16 gauge except for the floor.

I need to build a rotisserie first so I can swing the new box 180 degrees for fabrication.

I rough estimate is near a $1000 for the steel and maybe as much for the custom bending at a local fabricator... minimum charge $75...set up time then bending... might consider making parts for a second box once the set up time is paid for. Another possibility is buying my own 6 foot 12 gauge pan box brake but would need to build at least 3 boxes to break even. My own time and Mig welding not included.

Construction is fairly simple and most pieces needing bending is less than 5 feet long except for the head piece and tail gate. I would hope to be able to generate some pictures, sketches with measurements plus pit falls to avoid.

Plans are to safety the vehicle this Spring EVEN if I have to install a M101A trailer box temporarily or maybe one of the rusted box for a short while.

Grant is restoring a 20cwt trailer box and I may get some worth while experience with me as humble assistant.

Cheers
__________________
Bob Carriere....B.T.B
C15a Cab 11
Hammond, Ontario
Canada
Reply With Quote