[Wayne Hingley]

Hi Peter, Yes its definitely a little bit of a setback. My original intention was to use a good quality epoxy primer and paint. However, I was talked in to using the CS, as the guy told me I could paint over it (my fault for not doing my homework first). Anyway, Im back to my original plan. I don't need a "specialized" frame paint for this vehicle, as it is not a daily driver and will not be subject to winter road salt etc. Im thinking of redoing the "outside" portions of the frame only, and leaving the CS on the inner (hard to get at) sections that you cannot see.

My original engine paint was in very good shape, and looked quite good once I cleaned it up (several hours of cleaning). I am still looking for a high-temp paint in the right shade of grey. Everything I have found in "high-temp" is some type of aluminum or silver color. I sprayed a light coat of Krylon "light machinery grey" over the entire block, but Im sure it will not last too long in the hot areas. The Krylon is basically an exact match to the original color. I will keep looking for the same shade in a high-temp paint.