The Albion engine has a dry sump system invented by Thomas Blackwood-Murray the founder of Albion. The oil goes to the 5 main bearings and the 4 cylinders. It then drips off the main bearings and collects in slinger rings which sling it into the big end bearings after which it is thrown all around the engine. The oil should be run off at the end of each day according to the brass plate seem above the exhaust manifold.
The crankshaft was in excellent condition but missing the governor. I found one as well as the magneto cut out switch in Toowoomba QLD.
The clutch plate was beyond repair as the lining rivets had ground well into the plate. The Albion has the linings on the flywheel face and the spring plate with a spinning disc plate, the opposite to todays practice. Where do you get a new clutch plate these days? Well, you cut one out of a circular saw blade which, I might add, are extremely tough but designed to carry heat without distortion. It is a lovely clutch to use.
No.2 piston came out in 3 bits, so it was a case of welding it back together and hand filing down.
still more to come.
Rick