Once that was all done I took the roof and some other parts off to the sandblaster. Picked them up the next day and had to do some minor work on filling in a bunch of pinholes. I decided to try using JB Weld. Everything worked well except for taking a very long time to cure. I did find that by setting up a heater nearby it cured much faster. I think next time I will use the JB Quickweld. After this was done the usual POR15 steps were taken and then I began to spray the POR15 only to get one coat applied on the inside and I ran out. 6pm on a Sunday means the rest of the paint job will to wait until I can get another quart of paint.
__________________
Jordan Baker
RHLI Museum,
Otter LRC
C15A-Wire3, 1944
Willys MB, 1942
10cwt Canadian trailer
|