Alex thanks for the clarification on the Bedford MWR cover. Yes I too believe that the wire3 cover was similar in concept to the British one. I still think that there is a hinge to allow the front portion of the cover to lift up and if needed the entire cover can pivot up 90 degrees and then lift off from the generator. In the first pictures I posted there is clearly a rib or rod along the length of the cover right at the top of the curve on the cover. In one picture you can see it doesn't go right to the edge. I think it is like a piano hinge. If it was just for strength it seems very undersized.
As for the cover rotating up to 90 degrees and then lifting off. I believe the raised up ridge that is just below the cab frame/floor is what allows for this. That would be an almost identical copy of the British cover.
A few have made mention of a cab step as the reasoning for the ribs. When I fitted my chorehorse on the step I tried to get into the cab pretending there was a cover/step ontop of the chorehorse. It was way to high to be practical. This is why I believe there is a foot step built into the cover/bracket. In my first pictures the green arrow points to a box or air filter. The open top "shelf" the that little box is in is what I believe to be the new cab step. It is at the same height as the original step. Place you right foot on it. Pull yourself up and put your left foot onto the cover then step into the cab.
Lowering the cab step was also mentioned. However I don't believe this was done nor needed. The chorehorse with out the cage fits fine on the cab step. It would have even more room if I had taken the cage base off from below the fuel tank. I still think the original cab step was left in place. I believe you can just make it out between the fender and the small mud flap in the pictures above.
__________________
Jordan Baker
RHLI Museum,
Otter LRC
C15A-Wire3, 1944
Willys MB, 1942
10cwt Canadian trailer
|