View Single Post
  #2  
Old 17-04-15, 05:02
David Dunlop David Dunlop is offline
Registered User
 
Join Date: Feb 2006
Location: Winnipeg, MB, Canada
Posts: 3,599
Default

Robert.

Been watching your restoration with interest. An extremely fascinating CMP to restore, but in it's own way, very complex to do correctly when you consider all the specialized equipment needed to kit it out. I started one back in the early 1980,s and it took me seven years just to find all the bits I needed. Ended up three parts short before selling the lot to Don Perry in Edmonton and he was able to complete a fantastic restoration.

Your info is correct regarding two possible versions of this vehicle. Wilson Truck built all the bodies to a standard that the Army could kit out either with two chore horses (lower fixed and upper portable), or with one chore horse in the upper portable position and the lower spot occupied by a fixed 110 volt Onan. Somewhere in my files I have the model for the Onan. The dual chore horse setup was by far the most common configuration. Hense, when you look at the wiring diagram inside the lid of the panel box on the upper front right wall, the Onan circuitry is outlined with a dashed line as being optional. The 110 cable from the generator compartment to the front right corner of the wireless desk was there, but not used if dual chore horses were in use.

If the Onan was installed, the layout of its exhaust came very close to some of the internal wiring inside the gen box. To protect this wiring, a curved metal shroud came with the Onan, along with a spring loaded storage bracket and a small white warning decal with a red border and printing that explained how the shroud was to be installed when the Onan was operating. This bracket was mounted on the side of the gen box, in the upper right corner above the mounts for the two rifles.

As for the desk assembly. It was stored, as you noted in the brackets at the front end of the box. In use, it mounted on the left side of the body, below the Cipher Clerks window. Two large holes support the round hooks on the rear end of the desk frame and above them are a set of keyholes the side chains for the desk hook into. By the way, the Cipher Clerks window screen has a spring loaded mailbox flap fastened to the middle of it. This allows the Cipher Clerk to receive outgoing messages and deliver incoming messages when the penthouses on either side of the body are in use. Saves time running back and forth. The Cipher Clerks window is the left side rear.

By the way, when painting the interior, all of the inside of the gen box is the same colour as the exterior of the vehicle, including the two safety screens. The inside of the rear door is also the same colour as the exterior (as are the two blackout switches for the rear door and the gen box door). Lastly, all window frames inside, including the blackout curtain assemblies are also the exterior colour. The blackout curtain fabric is black.

Hope this helps a bit. Keep up the good work.

David

Last edited by David Dunlop; 17-04-15 at 15:06.
Reply With Quote