Sorry for the response delay, im on the road out in Alberta at the moment..ill be back in the shop by wednesday and will do my best to take the measurements in the pdf.At the moment my wheels are in use but I recently came into a pair of axles I think may be from a lynx but am not certain.they are a GM style axle front and rear chunk offset to the passenger side with cmp hubs and 20" combat wheels, but the steering is set up for the left side of the vehicle as seen from inside the passenger compartment facing the windshield.They are destined for another project and when I am sucessful in fitting an adapter to standard 10 on 11.25 pattern wheels there will be 4 combat wheels available. There is a local company called Vanguard steel that has large round bar stock in steel.i've used them for stock for flywheels and no doubt you could cnc some wheels from a billet cheaper than making a die for the rquired megaton press..just a thought.
ill put up the dimensions asap.
cheers
Corey
__________________
Stab it and steer...
|