Mine had two....
Good question David
My cab 11 had adjusting mechanism on both side....... is that original..??.. I really can't tell. The driver's side was bolted directly to the floor pan..... the passenger side had a one inch (2.4mm) board between the seat mechanism and the floor plate.
Will need to check the other cab 12 to see what they have.... if any thing still left.
Early seat frames DID NOT fold at the seat pans..... later on all the seats I have seen have a folding joint...usually rusted tight but easily free with some heat.
Cheers
PS...... just realize that in this picture you can see the roof molding curled up over the back of both seats... will have a better picture tomorrow
__________________
Bob Carriere....B.T.B
C15a Cab 11
Hammond, Ontario
Canada
|