A bit more
Today we completed the passengers side headlamp panel straightening and fitting, followed by tack welding the entire structure together to be strong enough to dismount from the vehicle to enable us to final weld the front panel from the inside.
Pic 1 shows the passenger side panel being temporarily bolted up. When we finally weld up the assy the temporary bolt holes will also be welded up.
Pic 2 shows the front end tack welded.
After the pics were taken we removed all the clamps and braces, thankfully there were no nasty surprises. Later in the week we'll fit the angle iron support bracket to the base of the assy and tack welding it in place. Then we'll the remove the whole lot for final welding.
Jerry
|