Quote:
Originally Posted by Private_collector
I initially hoped that my indicating 'everything is new' would allow any prospective firm to quote for what is in essence a very easy build.
|
That being the case Tony, and at the risk of stating of the obvious, can I suggest you do it yourself! There are no special tools required and everything you need to know is in your trusty Ford manual. In your case the only issue is compatibility, eg. crank/rod/piston combo, and you've already sorted all that. You just need to assemble it now, which I can assure you is a piece of cake. In fact it can be done by a 16 yo kid with no mechanical experience beyond Meccano and bicycles! And you don't even need a shed!
Seriously though I'd recommend you do it yourself, because quite apart from saving money it's probably the most enjoyable and satisfying part of the whole resto. The only tedious part I recall was adjusting the valve clearance after lapping the valves in, because you have to repeatedly reassemble the valve guides into the block and remeasure the clearance, to make sure you don't grind too much off the mushroom tips. Also I was using a hand driven grinder which didn't help matters much! However you can avoid all that by getting a machine shop to grind the required amount off each valve, after you've measured the initial clearances. Apart from that the only tricky part I recall was putting rings on pistons without a ring expander, as they have a nasty habit of snapping! These days you can probably buy the appropriate tool dirt cheap, otherwise get an engine shop to fit the rings. Also I notice the French block is relieved, which could make it tricky to install the pistons, ie. the rings may pop out of an ordinary ring compressor tool. You could probably trim one to fit the relief, otherwise get the engine shop to do that stage of assembly as well.
Apart from those areas the reality is you'd probably do a better job than someone on an hourly rate, and you can be pretty sure they've never even heard of a French flathead, let alone seen one! You're the one who knows it intimately and you're the one who sourced all the right parts, and you're the one with plenty of time to be fussy about assembly. Personally I'd rather torque every nut and bolt myself so I know it's been done to spec, not just to standard shop practice. Plus you get to measure every clearance yourself, which you'll never know if you give it to an engine shop. Also I doubt there'd be an engine shop in Australia as scrupulously clean as you!
Anyway Tony I think you should give it serious consideration, because this is purely an assembly job, not a rebuild, and having seen your work in this thread it's obviously well within your ability. All the instructions are in the Ford manual, and if you need any advice along the way you can always ask on MLU, just like everything else on a CMP. Like for example the importance of thermostats, which I seem to have overlooked as a kid!
