[Darrin Wright]

I collected the second batch of leather boots, this pair are for my project, and installed them to the hull. I utilised some heavy gauge galvanised wire to secure/tie-wire the boots to the exterior of the steering axle. So as to get the wire in the groove on the steering axle, I put a loop in each corner and this pulled the wire in tight against each flat surface. I have seen this technique used on other BGC. I have also seen 2 to 3 thin wire strands wrapped around the boot as well. This technique worked best for me.

The previous week I also put an order in for glass to be cut for the vision covers in the front of the hull. I collected these items on Saturday. They are of modern glass with a 6% tint. That should protect my eyes against sun glare whilst driving.

I also commenced some of the vehicle wiring, starting with the rear conduit section to the lights. Had to utilise a small cord/rope as a pull through to encourage the wiring through the conduit. I am going to run an additional wire, as an earth wire, to ensure that I have no problems with circuitry/earths in the vehicle lights.