[Tony Wheeler]

Sound logic Richard but when you do the math you find this winch is geared ridiculously low for recovery work. It's permanently in low ratio, which is designed for lifting 2 tons vertically over a few feet, not pulling a one ton vehicle horizontally over 120 feet! It can be calculated that would require 1400 turns of the handle, advancing the jeep only 1" per turn. The only way this winch would be remotely practical is with the handle set at minimal length, eg. 6" or less, and wound rapidly with one hand, in the manner of cranking a motor. That's no problem as the handle force required is less than 20lbs, so you could keep up a steady rate of 100 rpm or more, which would get the job done in a few minutes. However I believe it would be much better with a higher ratio and the handle set longer, so you could shorten it over the easy stretches and go much faster. That said though it's a helluva lot better than no winch at all!