[Darrin Wright]

This weekend before Christmas have done a few small/light jobs, such as:

lightly rubbed the painted surfaces back (the only section not rubbed back is the front interior) this is for a flat coat

made/completed the modification to my choke & throttle cables by brazing the spring loaded yokes to the inner cable, this is so they can attach to the balls/levers on the carby. The spring loaded yokes are from Mac's Auto, an item used to run a dual carby setup on a sidevalve V8, I cut the shaft in the middle & drilled a small hole down the centre of the shafts for the cable to go into to.

continued making clevis pins to suit all my square yoke ends for the steering/braking rods.

Painted my fuel tap and some more steering/brake rods.

Merry Christmas to all over the festive season and take care.